Below · −DI Continuously Above +DI
Helper filterSHORT
The panel has two colored lines: +DI (green) measures buyer pressure, −DI (red) measures seller pressure. Whichever is on top is the currently dominant side. This condition only reads these two lines.
What are DI+ and DI−?
The panel has two colored lines: +DI (green) measures buyer pressure, −DI (red) measures seller pressure. Whichever is on top is the currently dominant side. This condition only reads these two lines.
What does this condition say?
The crossover MOMENT isn't required. The only question is: is −DI above +DI? The dominance must persist without interruption on all candles for the Stability Window — even a single equal candle breaks the chain. Any SHORT signal that arrives while the condition holds passes.
How do you use it?
This is a helper filter. Its main use is as a gate next to a main criterion: the main criterion gives the entry, and if the dominance does not hold on that same candle the signal is dropped. Selected on its own, the bot opens the trade on the first candle where the condition holds — because it is an ongoing state, the entry can come early. To narrow it, increase the Stability Window from the panel, filter weak trends with ADX Level, and filter indecisive moments where the two lines stick together with Min DI Difference.
Does this condition close the position?
It only approves the entry; even if the dominance breaks afterward, it doesn't close the position. What closes it is your choice: if Profit Lock is on, PNL tracking takes over (while it's on, the Trailing Stop, Take Profit Net, Limit Take Profit Net boxes are locked); if it's off, the numbers you entered in these three are placed as orders on Binance and the position closes from there. DCA Rescuer and Liquidation Shield kick in under their own conditions; and you can always close from the panel with CLOSE or manually from Binance.
What is ADX for?
The white line ADX doesn't say direction, it says the strength of the move. Roughly: below 20 the market is sideways — trading is reluctant, signals come often and most fizzle out. Above 25 is usually counted as a real move. So if you enter a number in the ADX Level box in the panel, the bot only takes signals above that strength; DI+ / DI− Level and Min DI Difference do the same job on the line level.
